3 Quick Ways to Properly Break-In Your New Vape Coil
After replacing your coils, the next most important thing is to break-in your new coils. When you replace your coils, you must do the same for your wicking material. Therefore, you need to prime the coil and ensure that your wicking material is saturated. This will prevent the coils from burning your cotton wool, once hot, hence, preventing burnt flavors. Breaking-in your coil is also important in improving the lifespan of your coils and as well as intensifying your flavors.
This is the fastest way to get break-in your new coils. So how does this method work? First, you must start by creating a vacuum. This will see to it that the wicking material takes up the e-liquid faster. Once you have properly set your new coils, block the air inflows. This will ensure that no air gets in. Next, start taking some dry hits. When doing so, do not power your battery. Perhaps, the reason why this method is also referred to as the No Power Method. Take a maximum of five dry hits, all while checking not to flood your coils or get the juice into your mouth.
Also known as the vibrating method, this is also a no-power method of breaking-in new coils. With the shaking method, you just must fill your tank with your juice. After that, start shaking the vaping device as hard as you can. The reason for this is to create air bubbles. This method works under the assumption that the air bubbles created will help to push up the liquid faster. This is also among the very fast methods of getting your coils primed.
If you are in no hurry to start vaping, this method can be the most ideal. All you got to do is wait around for your coils to warm up all by themselves. The disadvantage of this method is that one must wait for about 20 minutes before they can start vaping. Other than that, this proves to be the best method of the break-in coil methods. Those who are patient enough are rewarded with high quality and uncompromised draws.
Priming your coils can be done in several ways. However, the above three methods prove to work for everybody, including newbies. Although most people will swear that some of these methods ruin the flavor, it might not be the case. What you do once you have primed your coils is very important. You are advised not to start by applying too much power. Apply a low voltage that will still enable you to get a good hit. Then start off by taking dry hits but do not inhale the flavor. Try taking a few hits then exhaling. Do these a few times and you are good to good.
Tags: coils, break-in, priming, suction method, shaking, wait, vaping, e-liquid, juice, tips